HVAC installation services across Nova Scotia
From a full new-construction package to a single furnace-to-heat-pump changeout, here's the work we do — all of it designed around a real load calculation and installed by Red Seal sheet metal workers.
New Construction HVAC
Complete ductwork, ventilation and HVAC packages engineered into the plans and coordinated with your framing, insulation and finish schedule. Built to code and past it.
New construction HVAC → HomeownersDucted Concealed Systems
Heat pump comfort with no wall units on show. The equipment hides in a ceiling, soffit or mechanical space and delivers even, quiet air through discreet vents — ideal for renovations, basements and additions.
Ducted concealed systems → Comfort & efficiencyHeat Pumps & Changeouts
Central heat pumps, central air and mini splits, plus furnace-to-heat-pump changeouts. Sized for cold-climate performance so the system carries the winter without leaning on backup heat.
Heat pumps & changeouts → Air qualityHRV & Ventilation
Heat recovery ventilators and general ventilation packages that exchange stale indoor air for fresh outdoor air while holding onto the heat you've already paid for. Range hood and bath exhaust integration included.
HRV & ventilation → Fix it rightDuctwork & Retrofits
Ductwork modifications, custom sheet metal transitions and cased coil furnace add-ons. If rooms won't heat evenly or the ducts roar every time the system starts, this is usually where the fix lives.
Ductwork & retrofits →Everything as one job
Design, sheet metal, equipment and commissioning come from the same crew. That's how a system ends up quiet, balanced and matched to the house — instead of a collection of parts that never quite work together.
Get a free quote
Real Rocky's install
Design, sheet metal and install under one roof
The reason these services fit together is that the same crew does all of them. We run the load calculation, fabricate the ductwork, set the equipment and commission the system — so nothing gets lost in the handoff between a designer, a supplier and an installer who never met.
That's how a system ends up quiet, balanced and matched to the house, instead of a box of parts that technically works.
- ✓ Load calculation and duct design in-house
- ✓ Custom sheet-metal transitions fabricated to fit
- ✓ Commissioned and airflow-tested before handoff
Proper sizing, clean sheet metal, code exceeded
Every service above starts with a room-by-room load calculation and follows ASHRAE, SMACNA and ACCA practice. That's the difference between a system that just runs and one that runs quietly, evenly and efficiently for years.
Tell us about your project
New build, renovation or a system that needs replacing — we'll size it properly and put a written number to it, free.